Fiberboard
Bitumen impregnated fiberboard
Fiberboard is a compressible sheet manufactured from bitumen impregnated wood fibers. It is a non-extruding, compressible joint filler to form and fill expansion and isolation joints for in-situ and pre-cast concrete construction. Fiberboard can also be used as a protection board to protect waterproofing systems against mechanical damage.
Downloads
Fibreboard_MS.pdf
MS
Fiberboard_MSDS_5.pdf
SDS
Fiberboard_2.pdf
TDS
- Excellent recovery.
- Low distortion.
- Easy to cut and handle.
- Will not extrude under compression.
- Rot-Proof.
- Available in 10, 20 and 35% asphalt content.
Fiberboard can be used as:
- Expansion joints filler in concrete pavements, walls and suspended slabs.
- As a filler for joints in roads, runways and bridges.
- Protection board for waterproof, coatings, and membranes.
- For structural isolation joints.
Sheet size: 1.22 m × 2.20 m.
Thickness: 10, 12, 18, 20, 25 mm.
* Variation of ± 5% may occur in the above numbers.
Store under cover, in a dry area on a flat, clean and sound surface.
- Fiberboard complies with DTp Specification for Highway Works, Dec 1991 series 1000 clause 1015.