Cookie Consent by FreePrivacyPolicy.com
Keyfix E

Tools and Equipment

Method of Use

Substrate Preparation

  • Substrate should be sound and clean
  •  Bars should be free from any loose rust deposits

 

Application

  • Holes should be drilled using a rotary percussion drill
  • After drilling, holes should be brushed and blown out twice, to remove all drilling debris
  • Bars and bolts should be degreased and all rust removed
  • Unscrew the protective cap, remove the insert plug
  • Insert the cartridge into the cartridge gun and attach the static mixing nozzle
  • Dispense sufficient material until an even colour is  achieved. Usually 10 ml / 0.34 fl.oz of extruded material should be adequate
  • Insert the nozzle into the base of the hole, apply pressure to the gun and slowly withdraw the nozzle as the hole fillsNormally it is enough to fill the hole to approximately two thirds full
  • Insert the stud / rebar / bolt into the hole with a twisting action, ensuring that is fully embedded
  • Allow the resin to cure fully before loading