Cookie Consent by FreePrivacyPolicy.com

Setseal AW309

Multipurpose water based acrylic, concrete curing compound

Setseal AW309 is a single component, water-based acrylic curing compound designed to impregnate concrete surfaces combining the benefits of a curing compound and hardener.

Setseal AW309 is designed to overcome drawbacks of many commonly used curing membranes that tend to provide a limited service life following the curing period of new concrete. It has good abrasion resistance and is compatible with several types of coatings.

Downloads
Setseal AW309_TDS_7.pdf
TDS
Setseal AW309_MSDS_14.pdf
SDS
Advantages
  • Recoatable.
  • Non-degradable, single component.
  • Enhanced concrete durability.
  • Increases the surface abrasion.
  • UV resistance.
  • Helps achieve concrete desired strengths.
  • Minimizes potential surface cracking and shrinkage.
  • Promotes a harder dust-free surface.
  • Can be spray applied to reduce labor cost.
  • Non toxic.
Applications

Setseal AW309 is mainly used for newly cast concrete and cementitious surfaces that contain GGBFS, PFA, microsilica, dry shake hardeners or limestone to retain sufficient moisture to ensure full hydration of the cement.
Typical application areas include:

  • High rise construction to eliminate water curing.
  • Runways and roads.
  • Roof decks.
  • Retaining walls.
  • Irrigation canals.
  • General floor slab and columns.
Coverage

The recommended coverage rate is 160 - 200 ft²/gal (4 - 4.9 m²/liter) applied in one coat.

Packaging

Setseal AW309 is available in 5 gal (18.9 ltr) pails, 55 gal (208.2 ltr) drums and 275 (1,041 ltr) totes.

Storage

Store in a dry area out of direct sunlight at temperatures between 40°F and 95°F (5°C and 35°C).
Setseal AW309 has a shelf life of 12 months from date of manufacture if stored in proper conditions in un-opened drums. The effectiveness of this product may be adversely affected if these conditions are exceeded and DCP Technical Department should be contacted for advice.

Standards

Setseal AW309 complies with ASTM C309/ ASHTO M-148 as Type I and II, Class A and B, when applied at the minimum recommended coverage rate.